As long as the computer does not clear the maintenance for a long time, it will be accompanied by noise, large computer heat, high CPU temperature, FPS playing games, and so on. Playing the game with high intensity, the computer will suddenly shut down automatically. These faults are caused by the computer without ash.
When it comes to computer clearance, many patients with obsessive -compulsive disorder may not be suitable for the ash clearance of air -blowing+brush, because although this protective components, it cannot be clearly cleaned up with the naked eye. This time, our brains are widely opened. Teach everyone the strongest cheats of the computer to clear the ash. The hair dryer/vacuum cleaner/electric toothbrush three prongs will bring you a different gray experience.
Suitable for a hair dryer/vacuum cleaner/electric toothbrush to clear ash
Remove the screw and open the host panel. At the edge of the chassis, we can use a hair dryer or vacuum cleaner to blow up most of the dust. The remaining dead angles can be wiped with an electric toothbrush.
In the position of the fan, the author does not recommend using a hair dryer, because there are more ash inside the fan. If the hair dryer is rash, it is likely to fly with dust, so using a vacuum cleaner is the most appropriate choice. Then use an electric toothbrush to polish, clean up some powerful dirty things, and continue to suck with a vacuum cleaner. This cleaning effect completely crushes the air.
In addition, the above -mentioned cleanup method has been completely renewed. At this time, remember not to use the means of washing. Washing can really make your host look cleaner, but it is easy to cause the aging and oxidation of various metal firmware. It is not conducive to the long -term use of the computer.
Still need to use the traditional gray part
As mentioned earlier, we still have to find a balance point in the component from being damaged and cleaned. It is suitable for the use of gas blowing and brushing or the main core hardware, such as CPU, motherboard, memory, etc. Well, be sure to clean up lightly.
Use the top of the brush to slightly modify the position around the motherboard and CPU to avoid scratching the motherboard, or use a brush to first brush the large area of dust, and finally blow it with air with a air that cannot be scanned by the corner corner. Blow away, be careful not to blow into the card slot. The impurities are cleaned up, and finally assembled in the hole.
Other parts that need additional attention
① If it is a hydraulic bearing fan or a fan that is relatively easy to disassemble, it may not be enough for lubricating oil for a long time, and the effect of buying some lubricating oil wipe is also good. Mute.
② The golden finger part of the memory strip (that is, the metal part of the card slot) can be wiped back and forth with rubber to make the surface smooth and no impurities.
③ If you need to change the silicon grease, we can wipe it gently with a soft cloth when cleaning up the old silicon grease. Be careful not to get the old silicon grease on the motherboard. Finally In contact.
④ The above method of clearance is not recommended to try novices.